• Program Bmw Garage Without Remote

Since one of the batteries was dead, I recommend that you replace the battery in the second remote also. Once you have fresh batteries in both remotes, I recommend that you erase all codes as shown in the procedure below. Once you have all codes erased, program both of the remotes as shown in the procedure. Here is a link for the full owner's manual for your garage door opener in case you need it:Owner's Manual.NOTE: The part number that you provided in your details is for the logic board in the garage door opener. The information in this answer is based on the Craftsman garage door opener model 139.53677SRT3.

It should be valid for your model.If you need more help, resubmit your question with additional details and the full model number of your garage door opener. You can normally find the model number under the light cover of the motor unit.

BMW Z4 - Key Remote ProgrammingThree methods to try:Method 1:1. Working from within the vehicle and with the doors shut2. Turn ignition to position 1 and back to off within 5 seconds.3. Remove the key from ignition and press and hold the unlock button for 15seconds during this time press the key lock button 3 times within 5 seconds.4. Release both buttons.5. Doors will lock and unlock to show correct programming hasoccurred.Method 2:To do this procedure you need to have one working key and one key that needs tobe programmed.1) Get in and close all doors.2) Turn on the ignition and turn off quickly. (No more than 5 seconds) to startthe process.

Next action must take place within 30 seconds.3) Remove the 1st key.4) Hold the key up near your left shoulder (this is so it is closer to the remotereceiver antenna.5) Hold down the unlock button and press the lock button 3 times. Release theunlock button and the doors lock which confirms the operation.6) Quickly repeat steps 4 & 5 for key #2 etc.If it does not work, try doing the keys in opposite order. Key 2 then key 1, vs 1then 2.Method 3:Alternate if you do not have a working remote1. Turn key to position 1 five times very quickly 2.

Remove key 3. Hold unlockbutton then press lock button 3 times, release unlock button.4. If you have another key do the same button pressing within 30 seconds 5. Turnon ignition to finalise.PLEASE NOTE: This programming procedure programs the remote control part of thekey.

Program Bmw Garage Without Remote

Any transponder chip for the immobiliser (starting of car) will not be programmed and must be done by aspecialist.